Car Intake Pressure Sensor for Pajero Compatible with Honda 079800-7430 Black Plastic

This intake pressure sensor is built to replace a worn or failed unit in Pajero vehicles, offering a direct-fit solution to restore accurate manifold pressure readings. A faulty sensor can cause rough idling, poor acceleration, and increased fuel consumption. By swapping to this black plastic sensor, you aim to bring engine performance back to normal. It is specifically compatible with the Honda part number 079800-7430, ensuring correct electrical and physical fitment. This sensor is a straightforward swap for the original component, requiring minimal mechanical skill for installation. The single unit packaging contains everything you need for the replacement task. No additional adapters or wiring modifications are necessary when fitted to a compatible vehicle.

Features and Construction

Understanding the build and compatibility of this sensor helps you assess its suitability for your vehicle. The component is made from black plastic, which is standard for automotive intake pressure sensors. Its design follows the original specifications for the 079800-7430 series.

Material and Build

The sensor housing is constructed from black plastic, providing a lightweight and corrosion-resistant body that withstands under-bonnet conditions. The electrical connector and internal circuitry are designed to match the original Honda-spec part. This ensures reliable signal transmission to the engine control unit.

Size and Practical Fit

The sensor features dimensions standard for this type of automotive component, allowing it to mount directly into the intake manifold or air duct. It uses the same mounting holes and sealing gasket arrangement as the factory part. No cutting or drilling is needed for installation on a Pajero with compatible fitment.

Uses and Placement

This sensor is intended for use in internal combustion engine intake systems where accurate manifold pressure measurement is required. It is most commonly used as a replacement part during routine diagnostics or after a sensor fault has been identified.

Vehicle Compatibility

Primarily designed for Pajero models that use the Honda 079800-7430 sensor type. It also fits other vehicles that share this part number, subject to cross-referencing by the installer. Always check your original sensor part number before ordering.

Engine Management Role

The sensor monitors intake manifold pressure and feeds this data to the engine control unit for air-fuel mixture calculation. A functioning sensor helps maintain smooth idle, steady power delivery, and efficient fuel use. This replacement restores that critical data stream.

Benefits and Buying Value

Choosing this replacement sensor offers practical advantages for vehicle maintenance, particularly for those with older or high-mileage Pajeros. It provides a cost-effective way to avoid diagnostic trouble codes and driveability issues.

Reuse and Low Maintenance

Once installed, the sensor requires no regular maintenance and is designed to last the typical service life of an automotive electronic component. If it fails again, replacement is a simple repeat procedure. Its plastic construction does not rust or degrade with normal use.

Why Choose This Product

It matches the original part number 079800-7430, reducing guesswork when sourcing a replacement. The black plastic build is consistent with factory specifications. This sensor addresses a common failure point in the intake system without requiring complex modifications.